The End Or Pin Of The PCB Part Is Aligned And Centered With The Pad Pattern!

Apr 06, 2023 Laisser un message

Due to the self-positioning effect during reflow soldering, some deviation is allowed in the installation position of the component. Allowable deviation range requirements are as follows:

1. Rectangular element: the width of the welding end in the direction of the width of the element is greater than 1/2 on the pad; The welding end and pad of the component must overlap in the direction of the length of the component; When rotation deviation occurs, there must be more than 1/2 of the width of the welding end of the component on the pad.

2. Small size transistor (SOT) : Allow X, Y and T(rotation Angle) deviation, but the pins must be all on the pad.

3. Small integrated circuit (SOIC) : Allow X, Y, and T(rotation Angle) installation deviation, but it is necessary to ensure that 3/4 of the device pin width is on the pad.

4. Quadrilateral flat package devices and Subcompact package devices (QFP) : It is necessary to ensure that 3/4 of the pin width is on the pad, allowing small mounting deviations of X, Y, and T(rotation Angle). Allow the toe of the pin to protrude slightly from the liner, but the liner must have 3/4 of the length of the pin and the heel of the pin must also be on the liner.